Sign-up for Newsletter

Puzzle Solution

---

Assembly Diagram for Standard Cassette Unit

---

1. Slide off the mounting end caps (1).
2. Mark the points where the blind should be mounted.
3. Drill two holes for each side and install the end caps (1) with their corresponding screws.
4. If not installed already, attach the nylon handle (a) with the screws provided in the perforated space of the blind's bottom profile (c).
5. When pulling down the handle, for upright cases the reflective aluminum should face out with the white side facing the case. For coffin cases the reflective aluminum should face in and the white should face out.
6. Insert the cassette (2) on the end caps, attached on the case, and secure with screws provided.
7. Mount the blind hook (b) on the lower side of the case, fixing it, if possible, below the bumper or molding.

Assembly Diagram for Units Without Cassette

on Upright Cases

1. Install the bracket plate (1a), with its corresponding screw, in the wall or ceiling of the case.
2. Insert the square spindle (2) into the crossed part (3) of the bracket plate, leaving the reflective side of blind outward, white inward.
3. To stretch the self-rolling mechanism (4), turn blind 360° in the direction marked by the arrow (5) 10 or 15 times, depending on the length of blind required and its desired tension.
4. Insert the round spindle in the circular part of the bracket plate (1b).
5. Insert the spindle holder (8) and turn it down.
6. Insert the blind stopper (9) in the bracket plate (1b).
7. If not installed already, mount the nylon blind handle (a) with its corresponding screws in the holes of the blind's bottom profile (c).
8. Mount the blind retaining hook (b) on the lower part of the case, fixing it, if possible, below the bumper or molding.

Parts Diagram for Woven Aluminum Blind

Non-Cassette

Part Number	Description/Specifications	Image
30518	Metal Mounting Bracket (OEM Version)
30510	Spindle Holder Safety Catch
30531	Stopper

Cassette

Part Number	Description/Specifications	Image
30521	2-Piece Mounting Bracket 55 mm. (2")
30532	Screws for Cassette Endcaps

Common Parts

Part Number	Description/Specifications	Image
30514	Spring Insert 650 mm. length (25") Diameter 27 mm. (1")
30522	Insert For Spindle Tube Diameter 27 mm. (1")
30516	Aluminum Bottom Profile Rail
30527	End Cap Profile
30513	Handle and Screw
30509	Hook and Screw (for bumper of case)